RevitWorks Door Factory 2015 Help

User Components

This is where the user can select two “extra” components to be included in the door.

The Door Factory comes with a number of user components including sills and sliding door pelmets.

The User Components can "flex" with the final door family by being constrained to any or all of the following:

· Panel Width & Height

· Panel Faces (Interior & Exterior)

· Jamb Faces (Interior & Exterior)

· Rough Opening Width & Height

· Wall Faces (Interior & Exterior)

As well as the above, the following parameters are also linked through to the relevant parameters within the final door family (if they exist)

· "Clear Opening Width" (for single and double doors)

· All panel to jamb/wall tolerances (i.e. Panel to Wall Gap Side2)

Creating New User Components

Refer to the support document “Creating New User Components”