RevitWorks Door Factory Premium 2017 Help   

 

Home | Start | Action | Jamb | Panel | HandleTrim | User | Identity | Create/Name | Glossary

 

Trim

This is where the user selects the type of trims (architrave, casing, moulding etc) required.

These can be different on the interior (swing side) and the exterior sides of the door.

Creating New Trim Profiles

Refer to the support document Creating New Trim Profiles

Trim Tab Definitions

The following describes parameter setting and values that can be set for the door within the Door Factory.

All the Type and Instance parameters can be changed in Revit after the door has been created.

All parameters are classed as Family Wide Parameters, Type Parameters or Instance Parameters

.

Trim Width

Family wide parameter for flat and splayed trims only

Trim Thickness

Family wide parameter for flat and splayed trims only

Trim Offset

Family wide parameter.
Offset off the opening side of the jamb.

Splay Width

Family wide parameter for splayed trims only

Splay Thickness

Family wide parameter for splayed trims only

Internal/External Trim Offset off Base

Instance Parameters

Offsets internal or external trims off the base of the door to allow for floor finishes to continue under

 


< back to Top

copyright 2015 by RevitWorks Limited | www.revitworks.com