 |
 |
RevitWorks Door Factory Help |
|
Home | Start | Action | Jamb | Panel | Handle | Trim | User | Identity | Create/Name | Glossary |
|
Trim
This is where the user selects the type of trims (architrave, casing, moulding etc) required. These can be different on the interior (swing side) and the exterior sides of the door.
Creating New Trim Profiles
Refer to the support document “Creating New Trim Profiles”
Trim Tab Definitions
The following describes the parameter settings and values that can be set for the door within the Door Factory. All the parameters can be changed in Revit after the door has been created and loaded into the project. All parameters are classed as Family Wide Parameters, Type Parameters or Instance Parameters.
Trim Width |
Family
wide parameter for flat and splayed trims only |
 |
Trim Thickness |
Family
wide parameter for flat and splayed trims only |
 |
Trim Offset |
Family wide parameter. Offset off the opening side of the jamb. |
 |
Splay Width |
Family wide parameter for splayed
trims only |
 |
Splay Thickness |
Family wide parameter for splayed
trims only |
 |
copyright 2011 by RevitWorks Limited | www.revitworks.co.nz